Votec 322 EPP 800mm Kit (HSF0000596) - STAUFENBIEL | RC-LEADER
Our VOTEC 322 EPP Shockflyer Kit is ideal for 3D acrobatic indoors or outdoors when there is little wind.
Made of sturdy yet elastic rigid foam material, the model forgives even the hanger when exercising daring 3D manoeuvers.
The low weight paired with the recommended cramped drive gives the model plenty of power reserves and pulling even in tricky situations
The distinctive Hamilton design in catchy orange gives the 3D artist an attractive look and cuts a fine figure on the floor as well.
- lightweight robust model made of EPP material (10mm)
- Preliminary control feeling
- tremendous 3D flight characteristics
- quick and easy to fix with superglue.
Needed to Complete
- 3 Servos
- ESC + connector
- Battery + connector
- 4-channel remote control system
|Approximate Assembly Time:||1-3 Hours|
|Flying Weight:||180 - 190g|
|Minimum Required Radio:||4Channel|
|Minimum Speed Control:||18A|
|Recommended Motor Battery:||2-3S Lipo 400-500mAh|
|Servos:||(3) 9g Servo|